Ice Cream Stitch Metal Enamel Sticker

A cartoon character holding an ice cream, with the cone, the scoop and the figure held as separate colour blocks. The layering is what gives it depth on a flat surface.

Where this sticker works

• Hard and transparent phone cases
• Laptop lids and hard laptop shells
• Hard plastic lunch box lids
• Lockers, journals and storage boxes

Surfaces to avoid: Silicone phone cases, fabric, leather with a soft grain, uncoated kraft card, textured or rubberised surfaces, and anything soft-touch coated. The adhesive needs a smooth, clean, dry surface to key into.

Who it suits

Anyone decorating a phone case, a lunch box, a laptop or a journal with a character piece.

Frequently asked questions

Will it hold on a lunch box?
On a smooth hard plastic lid, yes. Keep it away from the seal edge and hand wash around it rather than putting it in a dishwasher.

How do I apply it so it actually stays on?
Clean the surface with an alcohol wipe and let it dry fully. Peel the backing, position the piece, then press firmly for about thirty seconds. Leave it a full day before exposing it to water.

Will it leave a mark if I take it off?
No, it comes off without leaving a mark on the surface. If the adhesive is still intact you can stick it somewhere else, and if it has worn off, a small piece of 3M double sided tape will hold it on the new surface.