Gym Metal Enamel Sticker

A gym design built for a water bottle rather than a device, which is the reverse of most pieces here. The proportions are set for a curved bottle panel.

Where this sticker works

• Steel and hard plastic water bottles (hand wash only)
• Shakers and gym bottle panels
• Laptop lids and hard phone cases
• Journals, planners and hard tags

Surfaces to avoid: Silicone phone cases, fabric, leather with a soft grain, uncoated kraft card, textured or rubberised surfaces, and anything soft-touch coated. The adhesive needs a smooth, clean, dry surface to key into.

Who it suits

Gym-goers personalising a bottle, a shaker or a gym bag tag.

Frequently asked questions

Does it hold on a curved bottle?
On a gentle curve, yes. On a sharply tapered bottle the ends of the piece lift, so pick the flattest panel available.

How do I apply it so it actually stays on?
Clean the surface with an alcohol wipe and let it dry fully. Peel the backing, position the piece, then press firmly for about thirty seconds. Leave it a full day before exposing it to water.

Will it leave a mark if I take it off?
No, it comes off without leaving a mark on the surface. If the adhesive is still intact you can stick it somewhere else, and if it has worn off, a small piece of 3M double sided tape will hold it on the new surface.