Coffee Drip Metal Enamel Sticker

A pour with the stream held as a continuous raised metal line into the cup below. The unbroken line is the technical detail that makes the design work, and it is what a printed sticker cannot reproduce as cleanly.

Where this sticker works

• Reusable tumblers and travel mugs (hand wash only)
• Laptop lids and hard laptop shells
• Hard and transparent phone cases
• Planners, journals and desk organisers

Surfaces to avoid: Silicone phone cases, fabric, leather with a soft grain, uncoated kraft card, textured or rubberised surfaces, and anything soft-touch coated. The adhesive needs a smooth, clean, dry surface to key into.

Who it suits

Coffee drinkers personalising a laptop, a tumbler, a journal or a phone case.

Frequently asked questions

Does the thin part of the design lift?
The stream sits inside a continuous metal wall rather than as a thin printed element, so it does not peel at the narrow points.

How do I apply it so it actually stays on?
Clean the surface with an alcohol wipe and let it dry fully. Peel the backing, position the piece, then press firmly for about thirty seconds. Leave it a full day before exposing it to water.

Will it leave a mark if I take it off?
No, it comes off without leaving a mark on the surface. If the adhesive is still intact you can stick it somewhere else, and if it has worn off, a small piece of 3M double sided tape will hold it on the new surface.